(衬胶,衬氟)气动隔膜阀
简要描述:RETZ进口衬胶,衬氟气动隔膜阀不需要单独的阀杆填料密封结构,隔膜在切断介质的同时起到了阀杆的密封作用,其二是柔韧性很强的隔膜关闭可靠,甚至对污液都能做到良好的切断
- 品牌:RETZ
- 工况条件:开/关
- 温度/压力:P-T: 16bar@120℃
- 更新时间:2022/11/19
(衬胶,衬氟)进口气动隔膜阀由活塞式气动执行机构和隔膜阀组成,以压缩空气为动力带动传动螺杆,使阀芯上下运动,同时拉动膜片上下运动使其关闭和打开,并根据需要,可附装反馈信号装置或限位、定位装置等,以适应自控、程控、遥控或调节流量之用 RETZ (Rubber lined, fluorine lined) Pneumatic diaphragm valve is composed of piston type pneumatic actuator and diaphragm valve. The compressed air is used as the power to drive the transmission screw to move the valve core up and down, while pulling the diaphragm up and down to close and open. Feedback signal devices or limit and positioning devices can be attached as required to adapt to automatic control, program control, remote control or flow regulation
(衬胶,衬氟)进口气动隔膜阀 原理--
(单作用常开式)当气源进入气缸控制腔,隔膜下压,关闭阀门通道,当气缸控制腔无气源压力时,隔膜上升,阀门通道被打开 (Single acting normally open type) When the air source enters the cylinder control chamber, the diaphragm is pressed down and the valve passage is closed. When there is no air source pressure in the cylinder control chamber, the diaphragm rises and the valve passage is opened
(单作用常闭式)当气源进入气缸控制腔,打开阀门通道,当气缸控制腔无气源压力时,阀门通道被关闭 (Single acting normally closed type) When the air source enters the cylinder control chamber, open the valve channel. When there is no air source pressure in the cylinder control chamber, the valve channel is closed
技术规范 Technical specifications
空气驱动 | 压缩空气 4-7bar |
公称通经 | 15-200mm |
公称压力 | 1.0Mpa |
使用温度 | -10℃~80℃~150℃ |
连接方式 | 法兰 |
阀体材质 | 铸铁、铸钢、不锈钢 |
膜片材质 | PTFE、EPDM |
内衬材料 | 衬胶,衬氟,无衬 |
执行器 | 聚酰胺 |
安装方向 | 任意角度 |
可选附件 | 限位开关、定位器、电磁阀、减压阀 |
隔膜阀流量特征曲线 Flow characteristic curveof diaphragm valve